Hi, I see a lot of functions in FEMAP to mesh. I'm currently using femeshsurface2 to mesh and apply properties. I have now introduced points on surface and it needs to be used as "Mesh points on Surface". Fasteners/curves will be connected to these points . Is there any function to include mesh points. Appreciate any help.
Solved! Go to Solution.
I am trying to Create Mesh points on Surface. I am using the fastener hole locations and getting the points from the hole center.
I want to have nodes where the points are there. But Femap throws error only 150 mesh locations allowed on a surface.
Can any one help me on this
I am using Femap 10.02
Your solution is to split up the surface into smaller surfaces. Use Geometry \ Solid \ Slice. After meshing, use Tools \ Check \ Coincident Nodes. Also, be wary of placing mesh points close to edge curves. Unless you have a highly refined mesh, this will almost always result in slivers.