turn on suggestions

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

Showing results for

- Navigation
- Simcenter
- Forums
- Blogs
- Knowledge Bases

- Siemens PLM Community
- Simcenter
- CAE Simulation - Femap Forum
- Does Femap have a size limitation of Surface

Options

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content

10-19-2017 03:31 AM

2 REPLIES

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content

10-19-2017 07:40 AM

FEMAP does not directly have a limitation, however the Parasolid geometry engine that FEMAP uses does. The limitation however is not really on the size of geometry, but rather the coordinates. To maintain accurate precision when doing its modeling operations, Parasolid requires that all geometry is contained within a "box" of +/-500. Obviously that would not work for everyone so FEMAP implements a "Geometry Scale Factor"... which you can find and adjust on the Geometry/Model tab of the File->Preferences command. By default, FEMAP ships with this set to 0..Inches. That means that a scale factor of 39.37 is used (39.37 inches = 1 meter). You might have changed this to Meters (1.0) or Millimeters (1000.0) or set up a custom factor yourself. In any case, you should think of the size of the limiting box as 500 times whatever scale factor you have chosen (39.37*500= +/-19687)

Since you said that you are modeling a surface in Meters, I assume you may have set the scale factor to Meters also. Given that, you should still be able to model a 100x100 surface... but not if you place it too far away from the origin. Again, it is the coordinates that matter, not just the size of the geometry.

Hope this helps.

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content

10-19-2017 08:43 AM

See also this discussion:

https://community.plm.automation.siemens.com/t5/NX-Design-Forum/Max-Model-Size/td-p/325223

AMinati

Follow Siemens PLM Software

© 2018 Siemens Product Lifecycle Management Software Inc