Showing results for 
Search instead for 
Did you mean: 

Problem applying line loads to cuves


I am having issues applying loads to curves.


it appears as though in every location there are multiple coincident curves, and as such only 1 of these multiple curves has mesh associated to it. The only way I can apply loads is to add line loads to all the coicident curves. This is a problem as I have no confidence that the correct laods are being applied.


Is there any way to combine these curves? I have tried geometry, solid, clean up; tools, check, coincident curves; and modify, update associativity, automatic but to no avail.....


I have also tried deleting curves to ensure all redundant curves are removed.


Does anyone ave any suggestions?


The only work around to this problem that i can think of is to apply the load to all coincident curves, analysing the model and when I get the error "Unable to expand foce per length..." and then deleting the load applied to that curve, but I can't find away to delete a load on an individual curve in a load set if the load has been applied to multiple curves......


Any help would be greatly appreciated.


I tried to attach the model, but the model is too large to upload.






Re: Problem applying line loads to cuves

Siemens Phenom Siemens Phenom
Siemens Phenom

To offer the best possible solution, please send me the model and we will take a look at this -

sherman dot mark at siemens dot com