The title says it all actually. I am using NX 9.03
I have been looking for the best ways to simulate the bolt connections I need to create.
Since yesterday I noticed something strange. After a few days of modifying the rcf nastran config file I noticed that the 'memory requirements' are gone from the .f04 file. The entire section with requirements is gone.
Whatever I do to the rcf file, this section doesn't return.
I was experimenting with NX10 rcf settings like:
Where I believe the original was something like
I cannot verify this as I was stupid enough to forget making a backup before I started editing.
Can someone help me?
Thanks for responding!
Unfortunately those are not settings I can use. NX 9 does not seem to understand the 20.0X designation as I get errors every time I use something else than "xGb"