I prepared a modal analysis(geometry, mesh, materials, etc..) in Hypermesh and then generated a Nastran solver deck, a .bdf file, to import no Siemens NX 10 and solve it with Nastran Solver. (Case 1)
I also did the same analysis, from the beggining, in Siemens NX 10 and solved it (SOL 103 - Real Eigenvalues) with success. (Case 2)
Happens that when i import the .bdf file and then run the solver, goes everything ok but then i can't see the results, "No Results are Found".
I already checked both .f06 files, from Case 1 and 2 and i can see that in Case 1, Nastran was able to find solutions, wich match the ones from Case 2.
I also tried with bailout to -1 but goes the same way.
Solved! Go to Solution.
Does the input deck contain output requests (i.e. DISP(PLOT) = ALL)?
Is PARAM, POST, -2 specified?
Can you post the .f06 and .log files from the run?''
Can you post the NX syslog?
I didn't had any of those parameters defined but i already tried with them on and it worked.
Thank you very much!