Showing results for 
Search instead for 
Did you mean: 

Rotor flow analysis Nx 8.5


Hello ladies and gentlemen,


First of all, my problem is that I need to know wind disturbance caused by a spinning rotor in an enclosed area at around 500 RPM. I gave you a screen of where I'm at in the attachments below.


To be honest  I don't know where to start. This is all new to me since we're not going deep into CFD in my courses.

And after several hours of trial and errors trying to figure it out with not exactly the right tutorial for my needs. I gave my tongue to cat.


Essentially,  I want to replicate the sample principle used in this videos:


I need a procedure or reference tutorial so I can make the sim go a bit further!

Any help is much appreciated.