Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

Showing results for

- Navigation
- Simcenter
- Forums
- Blogs
- Knowledge Bases

- Siemens PLM Community
- Simcenter
- CAE Simulation - Simcenter 3D Forum
- differences between elemental and nodal stresses

Options

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content

09-29-2016 03:01 AM

Hello,

I am experiencing the following problem:

I have a cantilever beam, with a force acting on the free end. The simple and classical problem.

The elemental stresses are very close to teh theoretical ones, while the nodal ones (even averageg) are two times bigger!!! And that even if I reduce the element size. I am using Chexa20 elements.

Many thanks

Ionut

Labels:

3 REPLIES

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content

09-29-2016 03:14 AM

When I use Ctetra10, the differences (for the same element size) are smaller, but stil significant (40%). IN the same time, the results produced by the analysis are less precise that those obtained with Chexa (40% greater than the theoretical ones.

I am confused.

Thank you

Ionut

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content

09-29-2016 08:51 AM

A cantilever beam is not only a classic engineering mechanics problem, it is also a classic example of stress discontinuity in a FEA analysis.

I assume that you have solid meshed a rectangular prism to represent a beam, then fixed all of the nodes on one end face to make it cantilevered. If so, then the plane containing the fixed nodes has an infinite stiffness. The remaining mesh volume has a finite stiffness based on the supplied material properties.

As you refine the mesh, the stresses and stress gradients through the first layer of elements (connected to the fixed nodes) continues to increase, approaching infinity asymtotically.

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content

09-29-2016 01:49 PM

Dear JimB,

Thank you for your answer. I think I got your point. Thank you.

The two attached pictures present another model. It is a small assembly that comprises a steel plate, and a on top of it, a compozite enforcement. In the plate a crack has been induced (the red line in model.jpg). The other picture (half model.jpg) is the half model I used in NX10, with the symetrical conditions suggested in the picture. If I correctly understood you, it is normal to get significant differences between elemental and nodal stresses in the circled areas.

Am I right?

Many thanks

Ionut

Follow Siemens PLM Software

© 2018 Siemens Product Lifecycle Management Software Inc