cancel
Showing results for 
Search instead for 
Did you mean: 

Floor and Wall Milling

PLM World Member Builder PLM World Member Builder
PLM World Member Builder

I am having an issue where certain operations are trimming my cut area and I can not figure out why. The operation I first noticed it on is Floor/Wall Milling. If you reference the pictures below I am milling the pocket on an inside suface of a part and it keeps trimming my cut area off at the top surface of that part. Any ideas how to stop this?

 

C1.JPG

 

C2.JPG

 

C3.JPG

 

Learn online





Solution Information