Cancel
Showing results for 
Search instead for 
Did you mean: 

Gouge

Builder
Builder
Shank diameter not calculate while generating program it occurs gouge in nx 10
1 REPLY 1
Highlighted

Re: Gouge

Gears Esteemed Contributor Gears Esteemed Contributor
Gears Esteemed Contributor

What operation type?

What operation settings?

Did you enable to check holder collisions during calculation, if the operation offers it?

Your single sentence is not enough by far to give you any advise at all.

Stefan Pendl, Systemmanager CAx, HAIDLMAIR GmbH
Production: NX10.0.3, VERICUT 8.2, FBM, MRL 3.1.7 | TcUA 10.1 MP7 Patch 0 (10.1.7.0) | TcVis 11.4
Development: C (ITK), .NET, Tcl/Tk Testing: NX12.0 | AWC 3.4 Preparing: NX12.0

Employees of the customers, together we are strong Smiley Wink
How to Get the Most from Your Signature in the Community
NX Customization - Best Practice Guide

Learn online





Solution Information