cancel
Showing results for 
Search instead for 
Did you mean: 

New manual Drilling operations in NX10

Valued Contributor
Valued Contributor

Hello!

 

Excuse me this question: Should the new manual drilling operations, which came in NX9 work in NX10? I get no toolpath in NX10, in NX9 I get some. I create them out of the hole_making-template. Is there a special setting necessary which I don't know?

 

Werner

1 REPLY

Re: New manual Drilling operations in NX10

If they were created in 903 MP1 or later, then you need to instal 10.0.1..

Mark Rief
Retired Siemens

Learn online





Solution Information