Showing results for 
Search instead for 
Do you mean 
Reply

Quick mass changes to operations

Mark

You posted you were working on a utility for this but I dont think there were any more updates? Are you guys close?

Would be nice to test out. I was going to go back and bump the old post but I couldn't find it.

 

NX11.0.1
2 REPLIES

Re: Quick mass changes to operations

It is probably this thread:

http://community.plm.automation.siemens.com/t5/Discussion-Forum-NX/Utilites-to-Compare-and-Set-Opera...

 

Marek Pawlus, NCmatic

Production: NX 11.0.1
Development: C#, Tcl/Tk, CSE

Re: Quick mass changes to operations

We're finally ready to share. I will schedule something the week of Aug 8 or 15, directly whith whoever showed interest inthe original thread. 

Until then, there are several samples in UGOPEN... if you need to do something specific. 

Mark Rief
Retired Siemens

Learn online





Solution Information