10-15-2015 08:51 AM
Hello everyone, since yesterday I am trying to solve the problem as the topic above.
I made my own kinematics (5axis machine, itnc driver) and NX is runing tool only on points (machine control settings) in tool path simulation mode. I describe this problem in link belov becouse someone had have same problem like me:
PS. Strange, because machine code simulation MODE works fine on my simulation (arcs OK, plane spatial OK , etc)
Unfortunately still no solutions for tool path simulation (arc paths) ... Ehhhhh
Any idea how to fix it?
10-15-2015 09:18 AM
I'm not sure there is enough information here to tell what is happening.
Have you shown this case to GTAC?
10-15-2015 09:48 AM
Currently I didnt show this to GTAC because this is my first time when I get this "rare" issue
I made some my own kinematics & postprocessors before and I have never met this problem with common Tool Path Simulate.