Cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted

Re: Tools duplicating when placed into pockets

Gears Esteemed Contributor Gears Esteemed Contributor
Gears Esteemed Contributor

RE: Why did I not see it before?

Perhaps...

The WCS was far enough away from the mount junction that it was just "off screen"?

or perhaps hidden by other geometry?

 

(although if you have been programming for a while it would be wierd for this ALWAYS to happen...)

Ken Akerboom Sr CAx Systems Engr, Moog, Inc.
Production: NX10.0.3.5 MP16/TC11.2
I'd rather be e-steamed than e-diseaseled


Re: Tools duplicating when placed into pockets

Creator
Creator

Ken, I am a noob so it could have easily gotten by me. Another thing I thought of, I have been using mostly smaller tools and I just added holders to my tools. Maybe the tools were small enough that I didn't notice but once I added the holder it became obvious. Either way I am good to go. Thanks to everyone for helping me.

 

Kevin K.

Learn online





Solution Information