Cancel
Showing results for 
Search instead for 
Did you mean: 

Re: Undercut roughing with IPW and stepovers?

Phenom
Phenom
@Michael_Mannino, you mean it was ok after reversing or it went all nuts? I tried reversing with no luck. Path was violating part and didn’t do the smarter stepovers. Would be really nice to use boss milling for undercuts..

Re: Undercut roughing with IPW and stepovers?

Siemens Legend Siemens Legend
Siemens Legend

my sample worked fine, i did not save it, but will recreate it and post it...

Re: Undercut roughing with IPW and stepovers?

Siemens Legend Siemens Legend
Siemens Legend

Ok good news bad news

Good news I think I have it working. I had to give a negative top offset of 1/2 the flute lenght so it would gouge the square.

ScreenHunter_03 May. 25 14.47.gif

The bad news I cannot get it to respect the IPW. I added an offset that brought the side stock to the corner of the square, but it did work.ScreenHunter_02 May. 25 14.42.gif

Learn online





Solution Information