Cancel
Showing results for 
Search instead for 
Did you mean: 

Re: Which operation for groove Milling

Gears Esteemed Contributor Gears Esteemed Contributor
Gears Esteemed Contributor

I don't think there are plans, if this hasn't been reported yet.

To make sure this gets fixed in a future release, report this issue to GTAC.

Stefan Pendl, Systemmanager CAx, HAIDLMAIR GmbH
Production: NX10.0.3, VERICUT 8.2, FBM, MRL 3.1.7 | TcUA 10.1 MP7 Patch 0 (10.1.7.0) | TcVis 11.4
Development: C (ITK), .NET, Tcl/Tk Testing: NX12.0 | AWC 3.4 Preparing: NX12.0

Employees of the customers, together we are strong Smiley Wink
How to Get the Most from Your Signature in the Community
NX Customization - Best Practice Guide

Re: Which operation for groove Milling

Gears Phenom Gears Phenom
Gears Phenom

Also if slot has bigger width then the tool FL, is it possible to machine whole slot?

I think not.

 

Anyway,  report it to GTAC . It is good operation and it deserves improvement

---------------------------------------------
#♫ PB, 5ax, itnc, nx, vericut ♫ #

Re: Which operation for groove Milling

Genius
Genius

Hi Muddi,

 

Please report this to the GTAC. Probably they can give you a workaround.

 

In case they dont do it, I have a few ideas but non of them are clean/elegant.

Salvador Peregrina
Manufacturing Team Leader| NX 12.0.2

Re: Which operation for groove Milling

Valued Contributor
Valued Contributor

I am going to report the issue Smiley Happy

NX 11.0.1.11

Learn online





Solution Information