cancel
Showing results for 
Search instead for 
Did you mean: 

simulating stress on part

Genius
Genius

In NX CAM, is there a way to simulate the stresses being placed on a part and/or tool as it is being machined?

 

Vericut has something like this where stresses on the part will show up in red while you run the machine simulation. The resolution is not that great though.

1 REPLY

Re: simulating stress on part

We do analysis based on material removal rate for optimized feed rates.

 

For what you are asking, I would look at third party products. Some to start with:

Third Wave Systems  http://www.thirdwavesys.com/ 

Manufacturing Automation Laboratories http://www.malinc.com/

.

Mark Rief
Retired Siemens

Learn online





Solution Information