Showing results for 
Search instead for 
Do you mean 

NX9 - Rib Feature

by Siemens Legend Siemens Legend on ‎11-20-2013 01:42 PM - edited (1,995 Views)

In NX, you can use the Rib command to add a thin-wall rib or rib network to a solid body by extruding an intersecting planar section.

 

In this video, Ashley Eckhoff describes some of the enhancements in NX9 to the Rib Feature.

 

 Don't forget to subscribe to the NX Design Forum, so that you will get notification of new blog posts in your email.

 

Jerry