Cancel
Showing results for 
Search instead for 
Did you mean: 

Crane Runway width error

Solution Partner Pioneer Solution Partner Pioneer
Solution Partner Pioneer

Hi Community,

 

I'm getting an error on the multiportalcrane. I just imported the cranes library. dragged my crane in, changed the "Length of runway (L):" to 50 and the "Width of runway (B):" to 30. 

 

I attached pictures of error message and my dialog.

I'm using the latest version of Plant Simulation.

4 REPLIES

Re: Crane Runway width error

Gears Esteemed Contributor Gears Esteemed Contributor
Gears Esteemed Contributor

look here, try the updated library

 

https://community.plm.automation.siemens.com/t5/Plant-Simulation-Forum/Multi-portal-Crane-moveToposi...

Steffen Bangsow
freelance simulation specialist  
web: www.bangsow.eu
mail: steffen@bangsow.net

Re: Crane Runway width error

Solution Partner Pioneer Solution Partner Pioneer
Solution Partner Pioneer

Thank you,

 

I do have the newest patch installed.

 

I have been playing around with the "Width of runway (B):" and I have been able to make it bigger by 2 metres on every apply. If I use anything larger like jumping with 10 metres it gives me the same error again.

Re: Crane Runway width error

Gears Esteemed Contributor Gears Esteemed Contributor
Gears Esteemed Contributor

in version 13 there was a field in the dialog with this name (not in v. 14.1). 

Trigger the failure, open origine --> delete this line (it just try to write the value back into the dialog, but the field doesnt exits).

Steffen Bangsow
freelance simulation specialist  
web: www.bangsow.eu
mail: steffen@bangsow.net

Highlighted

Re: Crane Runway width error

Solution Partner Pioneer Solution Partner Pioneer
Solution Partner Pioneer

Thank you very much, I commented out that whole if statement and now its working.