Cancel
Showing results for 
Search instead for 
Did you mean: 

Re: Exitlocked option for different parts

Pioneer
Pioneer

Thanks a lot. It is really an easiest way to do it. I changed the my model. But the exit control of VG_1/VG_2 still doesn't work I think because of the capacity problem...

 

Re: Exitlocked option for different parts

Gears Esteemed Contributor Gears Esteemed Contributor
Gears Esteemed Contributor
it is hard to say without a look into your model, can you post it?
Steffen Bangsow
freelance simulation specialist  
web: www.bangsow.eu
mail: steffen@bangsow.net

Highlighted

Re: Exitlocked option for different parts

Pioneer
Pioneer

I added it. Thank you Smiley Happy

Re: Exitlocked option for different parts

Gears Esteemed Contributor Gears Esteemed Contributor
Gears Esteemed Contributor

you are right, you need another trigger for transport the containers.

I have changed some points in your model:

- init method --> unlock the exits to move two containers to the line

- entrance control of the assembly --> no call of containers

- Palette demontage: two interfaces --> connected with the assembly (the assembly station pulls the right part)

- entrancecontrol of drains klt --> wait until no boxes --> call a new container

 

Steffen Bangsow
freelance simulation specialist  
web: www.bangsow.eu
mail: steffen@bangsow.net

Re: Exitlocked option for different parts

Pioneer
Pioneer

Thank you very much. Sometimes it is very hard to see all little things especially for the beginners.

Best Regards, Beril