Reply

rectagular and circular pattern commands

Is there still a command for rectangular and circular patterns in free 2D? I have been trying to locate them but I am not finding them. I found some older threads but I cannot find them where it says.
1 REPLY

Re: rectagular and circular pattern commands

Look at the drop list under the Mirror command.
You will see the following:
Mirror
Scale
Stretch
Rectangular Pattern
Circular Pattern
Select the geometry first to enable the pattern commands.
Regards,
Rick B.
"maintenance@evapcomw.com"

wrote in message
news:maintenanceevapcomw.com.4xt0g0@noreply.bbs.industrysoftware.automation.siemens.com...
>
> Is there still a command for rectangular and circular patterns in free
> 2D? I have been trying to locate them but I am not finding them. I
> found some older threads but I cannot find them where it says.
>
>
> --
> maintenance@evapcomw.com
> ------------------------------------------------------------------------
> maintenance@evapcomw.com's Profile:
> http://bbs.industrysoftware.automation.siemens.com/vbulletin/member.php?userid=106208
> View this thread:
> http://bbs.industrysoftware.automation.siemens.com/vbulletin/showthread.php?t=46068
>