Showing filtered results for label: Sheet Metal. Show all articles

This is another topic request from the forum. It wasn’t requested directly, but there was a discussion about this functionality, and I just wanted to ...
Calder Ltd. is a manufacturer of high pressure pumping systems based in Worcester, UK. We just published a case study that has detailed engineering co...
A couple of really nice new sheet metal tools are in Solid Edge ST7. These tools can really speed up your process, and give you new capabilities that ...
This article discusses a Solid Edge workflow to create deep drawn sheetmetal parts that are typically created with a double-acting press. This perhaps...
These tools are all very welcome additions to the Solid Edge sheet metal toolbox. They kind of make me wish I were a sheet metal designer. Very cool s...
The sheet metal functionality in these two non-sketched features is very nice. You get nice, easy to edit geometry, even with Synchronous mode. But in...
With software this powerful and easy to use, designing parts for sheet metal is a pleasure.
There were some comments at the end of the last article, and I started to answer them in the comments, but the response quickly became too big to hand...
Synchronous sheet metal is pretty cool, even cooler than just normal synchronous modeling, if you’ll excuse that word. For example, if you make a part...
Labels