Does anybody else use Coordinate Dimensions In Solid Edge ST9 Draft? If so, maybe you can give me some advise on how to manipulate the dimension after it is placed. We have already succumbed to the fact that in order to switch between sides of a part (top/bottom or left/right), one must hold the "ALT" key to start a new aligment set. However, when the dimensions are too close and I need to move one out of the way, I find it difficult to control slight ajustments. I grab the handle and move it in the direction I need to and it zooms off the page. This is very frustrating.
Solved! Go to Solution.
Thanks for the reminder. We only just installed ST9 about two months ago. I neglected to get the IT dept. to install the patches. Let me get on that and I will come back to this topic.
I think YOu must upload this drawing for a further investigation.
I have tested a similar situation here with different drafting standrads and can not repordue Your video with any of them.
I suppose a special setting or option in YOur draft file rsponsible for that behaviour.
I recall seeing this unusual coordinate dimension "drifting" behaviour back in ST9 [on Windows 10] also, but I think it was fixed in an maintenance pack [could've just as easily been a coincidence, with a settings change]......and certainly have not seen it again with ST10.
Design Manager Streetscape Ltd
Solid Edge ST10 [MP5] Classic [x2 seats]
Windows 10 - Quadro P2000