We have our drawing templates stored in Teamcenter.
I now want to make slight changes to them. When I open the draft it gives me the option to save as or revise. Save as works, but I want to revise it.
When I click revise, then click new I get the message shown below.
The file doen't show the released flag.
I am an adminitrator and that doesn't help either.
What do I need to do?
I will be doing a big overhall of our draft template in the near future.
For this excersize, all I want to do is change how it opens so at this point I do not need to make it a new revision.
It opens as 2D Model. I want it to open as Working Sheet.
So all it is is, open, click the woking sheet tab, resave.
As a temporary and quick solution, try using Bypass:
Click OK, Try Revise.
It's important not to abuse Bypass and if you need to do this often, then you'd better set up the rights in the Access Manager application
I have now got it to REV 'B'. I open it up and do what I need to do then save.
When I close, it comes up with the upload document window, but the unique identifier is blank and the revision has a '-'. I cannot overwrite these cells.
If I need to revise a drawing, I open it in SE, then revise when I get the option.