Tracking Points for Centerline Drilling Operations
Centerline Drilling operations in Turning now allow you to specify separate tracking points for drilling cycles and non-cutting moves.
Created with NX CAM 10.0.2
You can specify separate tracking points for the drilling cycles and non-cutting moves in Centerline Drilling operations in much the same way as you currently can for drilling operations. NX automatically changes to the specified tracking point for each type of move.
To use this self-demo, save the attached part files locally and follow the instructions in the pdf document, or see the video below.
(If you have problems with the embedded player, you can download the attached .mp4 file.)
Do you have a question?
Post your questions or comments at the bottom of this Tech Tip. (You must be signed in to access this feature.)
About the Author
Bill Storrs is in the CAM Product Management Group at Siemens PLM software, Cypress California. His main focus is on CAM usability and learning support. He currently leads the CAM Learning Initiative Team whose mission is to provide users with a comprehensive collection of reference and training materials. He has an M.A. in Corporate Training and Development and has been in the industry for over 20 years.